So, what exactly has to be set? Well, generally you need to be sure the device is configured to the battery type (Flooded cell, AGM, etc) and bank size (total amp hours). Next you need to set the low voltage start up point. For that we need to know the voltage fluctuation that will work best for the batteries. That is, at what voltage should the start signal activate?
Well, we know that a deep cell battery will perform best if never discharged below 50% of full charge. The battery manufacturers state that a 12 volt system is at full charge at 12.7 volts or has a specific gravity of 1.277 per cell. The voltage at 50% of charge is 12.10 volts or a specific gravity of 1.172 per cell. So, setting the start-up voltage should be a no brainer! Just set it at the 12.10 volt value.
But, 11.7 volts calculates to about 10% of full charge, far below the target of 50%. The fact is, 11.7 volts will actually translate into about a 12.1 volts of a rested state battery. Your RV draws DC power constantly when not supported by shore power. Things such as an inverter, fridge, TV, lights, etc. all draw power, thereby not representing the actual rested state of the batteries.
Now let’s look at some of the advantages this option can deliver.
- If you leave your pets in the RV in camp, the auto-start will keep them cool should a power failure occur.
- If boondocking on a hot night, close the bedroom door and run only the rear air on the auto-start. It will keep you comfortable while only running the generator as needed.
- If you need to leave your RV for a couple of days the auto-start will look after maintaining the batteries.
Onan also offers a “Plug and Play” auto-start for existing rigs. Now, just a safety note. Be sure to deactivate this feature prior to doing any work on the gen-set or if it is going in for service.