Hydraulic Stabilizing Jack Troubleshooting:
1. System does not work, no lights illuminated on the control panel: Check the following:
Is the ignition switch in the Run position; is the transmission in Park; if more than 4 hours
has elapsed – turn the ignition switch off, then on again to reset.
2. Pump does not run and the jacks do not extend: Check the following: The
control panel – Touch pad fuse is blown or there is insufficient fluid in the reservoir.
3. The pump runs, but jacks do not extend: Check the following:
Check the 12 VDC fuse in the touch pad – Control panel.
4. If only one jack will not extend, and the others not. Check the following:
Check the 12 VDC fuse in the touch pad – Control panel.
5. All of the jacks fail to retract: Check the following:
Check the 12 VDC fuse in the touch pad – Control
panel.
6. Not all of the jacks retract: Check the following:
Check the retractor springs on those jacks that do not retract.
7. If the “Jacks Down” fail to go out when the jacks are retracted: check the following:
The fluid level in the reservoir is low.
8. While traveling down the road, the ‘Jacks Down” light flashes and the jacks are fully retracted:
The fluid level in the reservoir is low. Caution: use the Manufacturer’s recommended fluid.
Happy Camping
Fred b.